Macgregor MG-2107WHV 6.6kg 0.10s High Voltage Wing Servo

The MG2107WHV is an ultra thin (8mm), high speed wing servo, part of MacGregor’s range of high voltage digital servos designed for General use in RC Aeroplanes.

MacGregor’s HV servos are designed with motors and electronics that operate off the direct voltage of a 2-cell Li-Po, Li-Ion, or Li-Fe receiver battery pack. This eliminates the need for a regulator and lowers the chance for a power failure that can cause a catastrophic failure of your model. Also note that the HV servo specs are shown at the higher voltage (8.4V 2S LiPo) but will still operate on a standard 5-cell 6V NiCd, Ni MH battery with a reduction in performance of approximately 10% in speed and torque.

SPECIFICATIONS
Dead band: 2µs
Working frequency: 1520µs / 330hz
Motor: Coreless Motor
Gearset: Full Metal
Operating Voltage: 5.0 ~ 8.4V
Operating Speed (6.0V): 0.15sec/60°
Operating Speed (8.4V): 0.10sec/60°
Stall Torque (6.0V): 4.7kg.cm
Stall Torque (8.4V): 6.6kg.cm
Dimensions: 25 x 8 x 34.3mm
Weight: 21g (0.74oz)
Connector Wire Length: JR 300mm
Bearing: 2BB